|
|
Workshop
1a Plotting and Numbering |
|
|
Workshop 1b Linear Static Analysis of a Cutter |
|
|
Workshop 2 Analysis of Cantilever Beam |
 |
Workshop 3a - Stress Analysis of a Composite Plate with Variable Thickness |
 |
Workshop 3b Construction and Analysis of a Cantilever Beam |
|
|
Workshop 4 Postprocessing of a Ring Gear Assembly with Shrink Fit |
|
|
Workshop 5 Stress Analysis of an Extruded Part Modeled with Lumped Mass, Beam, Shell, and Solid Elements |
|
|
Workshop 6 Analysis of a Tong Part Imported from Parasolid |
|
|
Workshop 7a Sensitivity of a Cabinet Model to a Variety of Constraints |
|
|
Workshop 7b Symmetry Boundary Conditions on a Quarter Plate Model |
|
|
Workshop 8 Analysis of a Support Casting |
|
|
Workshop 9 Evaluation of Results in a Gear Assembly with Interference Fit |
|
|
Workshop 10a Stress Analysis of a Plate with Hole |
|
|
Workshop 10b Static Analysis of a Bail |
|
|
Workshop 10c Evaluation of Stresses for Best Design |
|
|
Workshop 11 Analysis of a Steel Plate Weldment Using Shell Finite Elements |
|
|
Workshop 12 Repair of Imported Wrench Geometry |
|
|
Workshop 13 Thermal and Thermal-Stress Analysis of a Heat Exchanger Channel |
|
|
Workshop 14 Analysis of a Three-Part Assembly Using Bonded Always MPC Contact |
|
|
Workshop 15a Analysis of a Hook Using ANSYS Workbench |
|
|
Workshop 15b Analysis of a Two-Part Assembly using Workbench |
