DRD’s
Introduction to ANSYS Classic, Part 1
This course focuses on linear static
analysis. Emphasis is on geometry import from CAD systems with some
modifications in the ANSYS solid and finite element modeler, performance of
simple solutions, and results postprocessing. DRD has highly customized this
course by developing our own course problems and adding some hand calculations
used to check results.
Approximately 50% of the course time is devoted to hands on workshops done
with coaching from the instructor.
It is strongly recommended for those attending
Introduction to ANSYS Classic, Part 1
that they enroll in the following Introduction
to ANSYS Classic, Part 2 course to gain experience and proficiency as fast a
possible.
|
Course Agenda
Chapter 1 Getting Started with
ANSYS
Chapter 2 General Overview of FEA
Chapter 3 Finite Element Attributes
Chapter 4 ANSYS Select Capabilities
Chapter 5 Finite Element Mesh Generation
Chapter 6 CAD Geometry Import to ANSYS
Chapter 7 Loads and Boundary Conditions for
Structural Analysis
Chapter 8 Solutions to Static Structural Models
Chapter 9 Evaluation of Analysis Results
Chapter 10 Evaluation of Local Stresses
Chapter 11 Modeling with Shell Finite Elements
Chapter 12 Geometry Repair
Chapter 13 Steady State Thermal and Thermal-
Stress Analysis
Chapter 14 Modeling of Assemblies
Chapter 15 ANSYS Workbench Environment |
Detailed
Description of
Workshops for this Course
|
Note: Please check the Training Schedule for course
schedule.
DRD may further customize the course at its discretion based upon the interests of the
course attendees.
Copyright 2004. DRD
Technology Corporation.