Shell Modeling and Meshing
The three buttons below provide links to the full Webinar (left) and Blog (right) over Shell Modeling and Meshing. Additionally, you can access the geometry used in this workflow with the Download File button(middle). This file was created in 2025 R2, and therefore must be opened with a similar or future version.
The three videos below showcase three different methods of creating Shell Connections within
Ansys Discovery and Mechanical, including Surface Extensions (left), the Connect Mesh Tool (middle), and the Weld Mesh Tool (right).
The two videos below show how you can bring your models from Creo (left) and SolidWorks (right)
into Ansys Discovery or Mechanical to support the Weld Mesh Workflow shown in Part 3 above.
The two videos below show how you can bring your models from Creo (left) and SolidWorks (right)
into Ansys Discovery or Mechanical to support the Weld Mesh Workflow shown in Part 3 above.
Weld Fatigue Workflow in Mechanical
The three videos below showcase a workflow for designing and analyzing welds for fatigue. Part 1 and Part 2 are sampled from other videos on this page to show how to create weld curves and use then use those to generate welds with the Weld Mesh tool in Mechanical. In Part 3, the model is setup and loaded for weld analysis in the Mechanical embedded nCode DesignLife addon.